Rennet and other coagulants when make homemade cheese (2024)

Coagulants and Rennet: Coagulants can be more than one type and are used to separate the milk into two halves-curds and whey. Naturally, this separation can happen even with no rennet due to acidification of the yogurt and kefir; however, the acidic level can be too high and take time. The lemon juice, vinegar and citric acid can coagulate the milk without rennet but frequently work best with hot milk.

The use of rennet allows to separate the milk before the acidification of the milk is too high and helps form hard curds and can be used at moderate milk temperature for an extended time. In other words - keeping the taste mild and at a higher PH level attracting specific bacterial cultures and hinder the growth of others.

Naturally, the rennet is made from the calf’s stomach. And the traditional recipe is as follows:

Dried and cleaned stomachs of a young calf, kid or lamb are sliced into small pieces and then put into salt water or whey, together with some vinegar or wine to lower the pH of the solution. The rennet mix is filtered after some time (overnight or several days). The crude rennet that remains in the filtered solution can then be used to thicken the milk. About 1 g of this solution can normally coagulate 2L to 4L of milk.

This is not the only one of the Rennet types. There is also microbial rennet, an enzyme extracted from fungi and suitable for vegetarians.

There is also vegetable rennet, and in the past yellow bedstraw plant, thistles and nettles. Cardoon and fig sap can also be used, but they can deliver a bitter taste to the cheese, so you must be careful when used.

The recombinant rennet is the next rennet type. It is artificially fermented chymosin, considered vegetarian. Still, it is not recognised as an organic product because the GMO technique was used.

When is added: In most cases, the rennet is added an hour or three after the starter cultures when the milk starts slightly to sour. Other cheesemakers add it together with the starter cultures, which work fine for small quantities of milk.

The different cheeses require an additional amount of rennet. Frequently the rennet must be diluted in water before adding it to the milk. It can be made as liquid, tablets, powder or rennet paste.

The speed of the coagulation depends on the following:

The particular animal: Sheep’s and Buffalo’s milk thicken quicker than cow’s milk. The goats’ milk coagulates slower than any of the mentioned kinds of milk.

PH: Lower PH, which occurs after acidification, increases coagulation speed.

Temperature: lower temperature reduces the speed or prevents it at all.

A temperature of up to 45C increases the speed of coagulation.

Protein content:

Rich in protein, milk speeds up the thickening.

Calcium/Calcium chloride:

Pasteurisation and hom*ogenisation change the structure of milk, removing some of the calcium and destabilising it slightly. When using any milk that is not raw milk to make cheese, add calcium chloride to increase the number of available calcium and help firm up the curds. Calcium chloride is added to the milk before the coagulant. Then added to the milk, it increases the yield and thickens the curd, reducing coagulation time. But it can lock moisture in the cheese and spoil the aged cheeses.

However, the fresh Cheeses are just fine, although they would not last long outside the fridge.

Rennet and other coagulants when make homemade cheese (2024)

FAQs

Rennet and other coagulants when make homemade cheese? ›

The lemon juice, vinegar and citric acid can coagulate the milk without rennet but frequently work best with hot milk. The use of rennet allows to separate the milk before the acidification of the milk is too high and helps form hard curds and can be used at moderate milk temperature for an extended time.

What coagulants are used in cheese making? ›

Common milk coagulants, such as calf rennet, genetically engineered chymosin, and microbial rennet, are costly and face restrictions due to ethical, cultural, and dietary concerns.

What is the best coagulant for cheese? ›

ANIMAL RENNET FOR HOME CHEESEMAKING

The most common coagulant throughout history is rennet, or rennin, the enzyme found in the stomach of young ruminants that have not been weaned from their mother's milk. Rennet is essentially an enzyme used to convert milk sugars (lactose) into lactic acid.

What is the alternative of rennet in cheese making? ›

Pig pepsin and chicken pepsin were used previously, however, not now. All successful rennet substitutes are aspartyl proteinases. Proteinases from Rhizomucor miehei, R. pusillus, Cryphonectria parasitica, Aspergillus oryzae and Irpex lactis are used for commercial cheese production.

What enzyme is often used to coagulate cheese? ›

Calf rennet contains two main coagulation enzymes: chymosin (aka rennin) and pepsin. Calf rennet is usually ~90% chymosin and ~10% pepsin. These are both proteases that will clot milk. This mixture of enzymes is one factor that leads to the reported flavor superiority of cheese made from calf rennet.

What are good coagulants? ›

The most commonly used inorganic chemical coagulants in water treatment. Aluminium sulfate is the most commonly used chemical for coagulation in wastewater treatment. Additional commonly used coagulants include sodium aluminate, ferric sulfate, and ferric chloride.

What are the typical coagulants? ›

Examples of primary coagulants are metallic salts, such as aluminum sulfate (referred to as alum), ferric sulfate, and ferric chloride. Cationic polymers may also be used as primary coagulants.

Can you use lemon juice instead of rennet to make cheese? ›

The lemon juice, vinegar and citric acid can coagulate the milk without rennet but frequently work best with hot milk. The use of rennet allows to separate the milk before the acidification of the milk is too high and helps form hard curds and can be used at moderate milk temperature for an extended time.

Can I use white vinegar instead of rennet? ›

NOTE: Classic cheesemaking uses ingredients like citric acid and rennet. But white distilled vinegar works too! It turns out a little different but still amazing. If you would like to go the more classic route you can pick up a cheesemaking kit that has everything you need minus the dairy of course.

What can I use if I don't have rennet? ›

Distilled White Vinegar – This is used instead of the classic citric acid and rennet ingredients. (4 to 5% acidic) Cheese salt – This is optional, you can also use flaky sea salt or kosher salt. Iodized table salt is not recommended.

What other coagulating agent can be used in the production of cottage cheese? ›

Milk-clotting enzymes are the primary active agents in the manufacture cheeses. Animal rennet, microbial coagulant and plant coagulant are used as milk coagulants in cheese making.

How to coagulate cheese? ›

Once the milk is acidified, whether through fermentation or direct acidification with citric acid, it's time to add rennet. The enzymes in rennet coagulate casein, the main protein in milk. Casein is contained in little bundles called micelles.

What enzyme is used to make mozzarella cheese? ›

One of the essential ingredients in making nearly every kind of cheese, rennet is a set of enzymes that cheesemakers use to coagulate milk and separate solid curd from liquid whey.

Is rennet still used to make cheese? ›

Historically, rennet was harvested from the stomach lining of young cows, sheep, and goats, and many cheeses are still made with animal rennet.

What is microbial coagulant in cheese? ›

Rennet is a coagulant, meaning its job is to thicken the milk and help turn it into cheese. It contains the enzyme rennin, also known as chymosin.

Is rennet better than vinegar? ›

The lemon juice, vinegar and citric acid can coagulate the milk without rennet but frequently work best with hot milk. The use of rennet allows to separate the milk before the acidification of the milk is too high and helps form hard curds and can be used at moderate milk temperature for an extended time.

What additive is used in cheese? ›

Cheese ripening salts are sometimes added to the more acid types of curd like Quark. Sodium hydrogen carbonate and calcium carbonate mixtures may be added along with salt at the rate of 30 g/kg of curd. These salts are used to reduce acidity, i.e. increase the pH value from the low values (~ pH4.

Top Articles
Latest Posts
Article information

Author: Terrell Hackett

Last Updated:

Views: 6291

Rating: 4.1 / 5 (52 voted)

Reviews: 83% of readers found this page helpful

Author information

Name: Terrell Hackett

Birthday: 1992-03-17

Address: Suite 453 459 Gibson Squares, East Adriane, AK 71925-5692

Phone: +21811810803470

Job: Chief Representative

Hobby: Board games, Rock climbing, Ghost hunting, Origami, Kabaddi, Mushroom hunting, Gaming

Introduction: My name is Terrell Hackett, I am a gleaming, brainy, courageous, helpful, healthy, cooperative, graceful person who loves writing and wants to share my knowledge and understanding with you.